Sealing interior joints is vital for preventing moisture infiltration. By carefully applying sealants to connections such as frames, doors, and walls, the overall quality and lifespan of the structure are significantly enhanced.
Choice of products to apply:
– DRY FIX® UNI / DRY FLEX® 1, 4 and 16
– DRY FIX® UNI / BIO FLEX™ ALLROUND and COOL
P10.1 Remove the paint in the area of surface damage. For sanding, use an (eccentric) rotary sander and sand down to bare wood.
P10.2 Fit the router with a half-round head bit (diameter 9.5 mm) and set the router to a speed of 22,000 rpm.
P10.3 Rout out the joint 10 mm wide and 10 mm deep; both the front and the rebate up to the glass line. Centre the cut over the joint and follow the curative procedures when encountering damaged wood (wood unevenly coloured, soft and crumbling).
P10.4 Measure the wood moisture content of the joint with the EASY-Q™ wood conditioner CS1. If the moisture content of the wood is too high (≤ 18%), allow it to dry naturally in the open air.
P10.5 Remove upstanding wood fibres on the contact surface by sanding. Carefully remove wood residues and dirt.
P10.6 Apply DRY FIX® UNI to the contact surface thinly but fully. Allow to penetrate for at least 20 minutes. Check within 45 minutes that the DRY FIX® UNI has penetrated properly (the treated surface will then have a nearly matte finish). Remove (dab off) any surplus DRY FIX® UNI with absorbent paper towel or a lint-free cloth. The repair paste should preferably be applied immediately after treatment with DRY FIX® UNI. If the repair paste is applied later, this should be done within 24 hours after applying DRY FIX® UNI and the repair surface should be checked for contaminants.
P10.7 With the EASY-Q™ buttering Knife or the smallest EASY-Q™ stainless steel modelling knife, apply DRY FLEX® or BIO FLEX™ into the joint in such a way that an optimal coating (contact) of the wood is obtained.
P10.8 Seal the joint with DRY FLEX® or BIO FLEX™. Avoid air inclusion and model the repair according to the RCI method.
P10.9 After the DRY FLEX® or BIO FLEX™ has cured, remove the top layer (amine layer) by sanding. If necessary, sand the entire surface mechanically smooth and even. Interfering imperfections and transitions between wood and the applied DRY FLEX® or BIO FLEX™ must not be visible afterwards. Carefully remove the sanding dust.
P10.10 Smooth out any small irregularities (surface filling) according to method P9.
P10.11 Treat according to painting advice. Always use a primer as a base. When time is important factor a quick drying primer can be used.
The number behind the type DRY FLEX® refers to the curing time. It should be noted that the curing time of the products depends on the applied layer thickness and the temperature of the surrounding environment.
